From the page: The iPhone still has chapters ahead
Idea 7
Stand made from reclaimed wood
Desk stands for phones were born in woodworking shops as an exercise in thrift: a block of hardwood, two cuts and done. It works because wood has enough weight and friction to hold the device at an angle without tipping — the wide base shifts the center of gravity downward.
What you need
- A piece of sturdy wood (peroba, eucalyptus or leftover furniture wood, about 12 x 8 cm)
- A handsaw or coping saw
- Medium and fine sandpaper
- A chisel or small file to open the groove
- A ruler and pencil
How to make it
-
1
Mark a rectangle of about 12 x 8 cm on the wood and saw it — this proportion gives stability without weighing too much on the table.
-
2
Cut a vertical groove 1 to 1.5 cm wide and 1 cm deep at the top, using the chisel — that's where the phone rests; measure the device's thickness first.
-
3
Make two diagonal cuts on the front of the base or sand an angled bevel, so the phone leans back and doesn't slide forward.
-
4
Sand everything, starting with the medium grit and finishing with the fine one, rounding the corners — this prevents splinters and improves the finish.
-
5
If you like, cooking oil applied with a cloth gives a slightly darkened tone and protects the wood.
Finishing touches
Leave the groove 2 mm wider so it fits even with a case on. You can also cut a second side channel for the charger cable to run behind.
This is one of the ideas from the full page — see all the possibilities.
This page feeds the collective knowledge 🌱 — every discovery makes the next answer better.